You have decided to purchase a Bosch 4100 table saw with crosscut sled. But how do you decide which sled is best? We’ll take a look at the benefits and features, price and size. After you’ve made your decision, read on for a step-by-step guide to installing the sled. We’ll also go over some basic maintenance tips.
Features
The Bosch 4100 table saw is equipped with a crosscut sled that features adjustable fence settings and zero-clearance kerf. The sled is easy to install and read with 1/2 degree graduations and a hairline indicator. The sturdy aluminum fence and adjustable MDF face glide smoothly along the table. There are a few things to keep in mind when assembling the saw.
The sled is designed to replace the miter gauge and offers a large base with a fence to secure the workpiece. There are several different styles, and they all make crosscutting much easier, especially for smaller projects. The sled can be a simple or complex tool, depending on your needs. However, it is important to note that sleds can be more expensive than a miter gauge.
Benefits
The Bosch 4100 table saw’s crosscut sled has a lot to offer a woodworker. For starters, this sled features zero clearance, which means that the blade is never further from the sled’s base than it is from the stock. Zero clearance also makes it easier to set the sled up by lining up the desired cut location with the sled’s edge.
First, the sled’s base should extend 1/4″ beyond the blade, and a runner should be pressed against the miter gauge slot. Once in place, the front fence should be clamped in place. Use the pre-drilled holes to guide where the fence should be placed. After a few minutes of clamping, you’re ready to glue and clamp the sled.
Price
Purchasing a sled is an essential part of table saw maintenance and upkeep. When buying one, make sure to look for a fence that can hold the sled and blade in place. The fence should also be square with the blade, but the face of the sled does not need to be square with the blade. You should choose one that has a fence with a height higher than the height of the saw’s blade.
When purchasing a sled for your table saw, make sure to purchase the right size. It is easy to read, and comes with 1/2 degree graduations and a hairline indicator. It is built with an aluminum fence and adjustable MDF fence face. You will also find that the various components slide easily. While sleds are not recommended for every table saw, they can be a good investment for beginners.
Size
The Bosch 4100 table saw’s crosscut sled size is important for a variety of purposes, from general woodworking to woodworking with specialty materials. The sled size you select should correspond to the crosscut width of your table saw blade. However, you must pay attention to the crosscut sled’s crosscut kerf. You should also make sure that the sled is properly squared to the blade.
You will need to cut a piece of MDF approximately one-fourth inch wider than the width of the blade and the miter slot. Line up the MDF spacer with the edge of the base and clamp it in place. Next, you will need to glue the runner to the base, pressing it against the MDF spacer. When done, nail the runner to the base. Once the runner is secured, you can cut the final sled size.
Installation
Once you’ve unpacked your new Bosch 4100 table saw, you should first install the crosscut sled. You can use the installation guide to help you get started. Afterward, you can install the rear fence and clamp. Before squaring up the blade, be sure to mark the sled with a pencil. Then, use a screwdriver to secure the runner to the base.
This sled has T-slots on its base to accommodate the included hold-down clamp. This clamp holds your workpiece in place while you work, and eliminates any possible side-to-side play. It’s especially helpful for miter cutting. Alternatively, you can use the included sled to secure your workpiece. Then, place the sled over the workpiece, and attach the T-slots on the bottom to fasten the clamp.
