You can adjust the table saw angle by adjusting the stop, which is usually located on the table top. This stop is designed to zero the table saw in at 90 degrees. If the saw has been in use for a while, you might have accumulated some sawdust and need to adjust the angle. The stop may be locked with a bolt, stud, or locking nut. If this is the case, you can adjust the table saw’s angle with a digital angle gauge.
Unlocking the table saw
When you first set up your table saw, make sure you lock the rip fence lever. You also want to make sure that the fence is parallel to the blade and that the miter gauge knob is tightened properly. When you are finished assembling your table saw, slide out the saw using its carrying handle. Using a push stick is a great idea to keep your hands away from the blade and to reduce the risk of injury.
Before you begin using your table saw, you should first read the instructions that come with it. If you don’t understand the instructions, you should refer to the product manual or contact the manufacturer for assistance. In most cases, the instructions for assembly are provided. Then, you need to insert the tabs into the table’s opening and turn the cam lock knob clockwise a quarter-turn. Once you’ve done this, you can start using your table saw!
Checking if the blade is aligned to the miter slot
You must ensure that the blade on your Dewalt table saw is correctly aligned to the miter slot before you can start cutting wood. Ideally, the blade should be less than.004” off the slot. If you can’t see the miter slot, you can move the rear trunnion bracket a bit. However, this may result in a kickback.
Before you can check if the blade is aligned to your table saw’s miter slot, you must unplug it. Then, remove the trunnion brackets, if necessary. Use shims to move them 90 deg. You can use a feeler gauge to tighten it.
If you’re unsure of the exact alignment of the blade to the miter gauge, you can use a dial indicator. Place it in the miter gauge’s miter slot, and make sure it’s set to 90 degrees. If it isn’t, you may want to change the blade or use a 45-degree blade.
Using a tape measure to check for proper alignment
Using a tape measure to check for the proper blade alignment on a Dewalt table saw is an easy way to ensure that your blade is parallel to the trunnion. To check this, insert the same feeler gauge at the front and rear of the blade. You can also use a combination square to check for the proper alignment. Once the blade is aligned properly, slide the miter gauge back into the slot of the arbor nut and make sure that it’s not slipping out of place.
Using a tape measure to check for the proper alignment on a Dewalt tablesaw is a simple procedure. First, line up the point of the triangle on the blade with the mark on the miter gauge. Then, use a feeler gauge that fits the miter gauge. If the blade is off by.002 inch, you can tap the rear trunnion bracket with a hammer and a pointed stick.
Using a digital angle gauge to adjust the table saw’s angle
Using a digital angle gauge to adjust a table saw’s tilt is an effective way to get the right blade angle for your specific needs. It is easy to use, and comes with a magnetic mount to the table saw blade. After attaching the gauge to the blade, you simply crank over the angle you need and watch the display move with the blade. There are also dedicated setup blocks and drafting triangles for 45-degree settings.
The Wixey Digital Angle Gauge is an affordable, easy-to-use tool that helps you measure angles accurately. The magnetic flanges are extremely strong so that the angle gauge will securely adhere to your table saw blades. The Wixey digital angle gauge also includes a zero button, so that you can calibrate the gauge to any surface. Using a digital angle gauge can make your cutting jobs a breeze.
