The radial arm saw has a sacrificial front table that you should change from time to time after usage. The majority of radial arm saws are constructed with a steel frame and a wood tabletop. The primary factor for this it that the saw blade will permeate the tabletop for many cutting operations.
If you are looking for a good read on things to look for in a good table saw then please visit the home page of this web site.
Things You’ll Need
- Shatterproof glass
- Sheet of 3/4-inch MDF (medium density fiber board)
- Adjustable wrench
- Drill with bit
- Framing square
Steps
- Disconnect the radial arm saw for security.
- Raise the saw to get access to the table.
- Eliminate the old top.
The majority of radial arm saws have a three-part table
- The rear table serves as a clamp to hold the rip fence in location.
- The rip fence supports the wood and keeps it perpendicular to the blade.
- The front table is the cutting surface area.
Many cuts on the saw will cut through the fence and the work product and into the front table. For a lot of radial arm saws, the rear table and the rip fence are secured in place in between wing bolts at the back and the front table.
When the wing bolts are loosened up, the rear table and the rip fence are detachable. The front table is connected with 4 or more recessed bolts that are accessible under the saw where it connects to the steel base.
Cut the brand-new top to size, utilizing the existing front table as a design template. Drill the bolt holes to match the old top.
Among the very best products to utilize for the front table is 3/4-inch medium density fiber board (MDF). It is economical, resilient, simple to deal with and will not hurt the blade when it is cut into.
Connect the brand-new top to the steel frame. Set up the rip fence and rear table.
Inspect the saw for square. Lower the saw till the blade consults with the front table. Raise the blade 1/4 turn.
Location a framing square on the leading edge of the front table and beside the blade. Pull the saw forward. The blade ought to not go into the leading or retreat throughout travel.
Change as needed by
loosening up the bolts from under the front table where it connects to the steel base. Re-tighten the bolts.
Examine the table to be sure it is flat. Lower the blade up until it contacts the front table. Raise the blade 1/2 turn. Pull the blade forward gradually, keeping in mind the space in between the table and the blade.
The space needs to be the same throughout its travel. Change the saw to 45 degrees left and right, and inspect the space once again. It ought to preserve the very same space throughout the blade’s travel.
If it is not flat and real, shim the top from listed below as needed till it holds true.
Start the saw and lower the blade 1/8 inch into the table and pull forward. Repeat for 45-degree cuts left and right of center.
This will offer reference marks on your brand-new table.
Tips & Warnings
- Use shatterproof glass whenever you switch on the saw.
- Conserve the old front table as a design template.
- It is best to round the front corners of the brand-new front table to prevent sharp edges.
- Make certain to countersink the bolts so that they will not interfere with the table’s surface area.
- Constantly detach the power prior to dealing with power tools.
- Use shatterproof glass when running power tools.
